96
97
FCC regulations
This mobile phone complies with part 15 of the FCC Rules . Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation .
This mobile phone has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules . These limits are
designed to provide reasonable protection against harmful interference in
a residential installation . This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications .
However, there is no guarantee that interference will not occur in a particular
installation . If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna .
•
Increase the separation between the equipment and receiver .
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected .
•
Consult the dealer or an experienced radio/TV technician for help .
Caution:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to operate
the equipment .
FOR YOUR SAFETY
RF exposure information (SAR)
This phone is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the United States, Industry Canada
of Canada .
During SAR testing, this device was set to transmit at its highest certified power
level in all tested frequency bands, and placed in positions that simulate RF
exposure in usage against the head with no separation, and near the body
with the separation of 0 .4 inches (10 mm) . Although the SAR is determined
at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value . This is because the phone
is designed to operate at multiple power levels so as to use only the power
required to reach the network . In general, the closer you are to a wireless base
station antenna, the lower the power output .
The exposure standard for wireless devices employing a unit of measurement
is known as the Specific Absorption Rate, or SAR .
The SAR limit set by the FCC
is 1.6 W/kg, and 1.6 W/kg by Industry Canada
.
This device is complied with SAR for general population /uncontrolled
exposure limits in ANSI/IEEE C95 .1-1992 and Canada RSS 102, and had been
tested in accordance with the measurement methods and procedures
specified in OET Bulletin 65 Supplement C, and Canada RSS 102 . This device
has been tested, and meets the FCC, IC RF exposure guidelines when tested
with the device directly contacted to the body .
The FCC has granted an Equipment Authorization for this model phone with
all reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines . SAR information on this model phone is on file with the FCC and
can be found under the Display Grant section of www .fcc .gov/oet/ea/fccid
after searching on
FCC ID: SRQ-Z987
.
FOR YOUR SAFETY
Содержание Grand X Max+
Страница 1: ...ZTE Grand X Max User Guide ...
Страница 58: ...112 NOTES Notes ...