ZOOM B2.1u
6
Controls and Functions / Connections
Module selector
Top Panel
Rear Panel
Switches between play mode and edit mode. In edit
mode, the knob selects the module for operation.
[
W
]/[
Q
] foot switches
These switches are used for selecting patches,
switching effect modules on and off, controlling
the tuner, and other functions.
[USB] connector
Allows you to connect the B2.1u. to a
computer, for exchanging audio data.
[BALANCED OUT] connector
This XLR connector can be used to
send a balanced line-level signal to
PA equipment, recording devices, or
similar.
[PRE/POST] switch
Selects the point where the signal supplied
at the [BALANCED OUT] connector is
obtained. In the "POST" position (switch
engaged), the signal is branched at a point
after effect processing, and in the "PRE"
position (switch disengaged), it is branched
at a point before effect processing.
[GROUND] switch
Determines whether the [BALANCED OUT]
connector is grounded or not. In the "LIFT"
position (switch engaged), the ground pin of
the [BALANCED OUT] connector is
uncoupled from the signal path. In the
"CONNECT" position (switch disengaged),
the ground pin is connected.
[STORE] key
Serves for storing edited patches in memory.
Computer
Mixer
BANK [-]/[+] keys
In play mode, the keys serve for directly switching
to the next lower or higher bank.
In edit mode, the keys switch the effect type for the
currently selected module.
