¾
You may also need to check that the DHCP client on the router’s WAN port
is enabled. If you need help, look in your router’s manual or contact your
router manufacturer.
¾
If that does not solve the problem, you may need to contact your cable
service provider and give them the MAC address of the router’s WAN port.
Cable Modem Rear Panel
LAN Reset RF (Cable) Power ON/OFF
Port Description
Connect your Ethernet cable between this port and a
computer or router.
LAN (Yellow)
Press this button for 5 seconds in the unlikely event
that you need to restore factory default settings.
Reset
RF (Cable)
Connect your coaxial cable line to this port.
POWER (AC IN)
Connect the supplied power cube to this port.
Push the button in to turn the power ON. Push the
button again to turn the power OFF.
ON/OFF
Please note the following:
¾
Do not block the modem vents in any way.
¾
Do not place the modem near a heating or air conditioning duct, in direct sunlight,
anywhere susceptible to drastic temperature changes, or where it’s very hot or very
cold.
