Page 7
©2017 ZOO FANS INC. ALL RIGHTS RESERVED
1650 38
th
St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852
zoofans.com
REV 10042017
SECURING THE FAN
STEP 1: Prepare
Hanging System before Installing Fan in Ceiling
The IC20 Drop-In includes a four (4) wire Gripple® hanging system to support the unit on the drop ceiling grid. This system
relieves additional weight load on the existing ceiling frame to avoid sag or unleveled portions of the ceiling, and also
provides a safety system to secure the fan independently of the ceiling.
WARNING
:
The Tethers MUST be installed properly to ensure safe operation of your ZOO Fan.
1.
Place the eyelet end fixings at the end of each Gripple wire over the mounting studs on BOTH SIDES of the plenum
(two per side), and secure with remaining wing nuts as shown below:
INSTALLATION TIPS
:
•
Only uncoil enough of the Gripple wire to attach the end fitting to the stud
•
Tape the remainder in a coil on the
top of the plenum so it’s out of the way while l
ifting the fan into the ceiling
FOR BEST RESULTS:
•
Place duct tape along the outside, bottom edge of the plenum to seal between the plenum and the diffuser in order
to maintain optimum air circulation
