Zonix FP4640 Series, Руководство пользователя

Страница: 5 / 28

Pin
Setscrew
Downrod
Blue, brown and
orange Lead
Hanger
Ball
How to Assemble Your Ceiling Fan
Figure 2
Figure 1
Figure 4
Figure 5
5
Ceiling
Canopy
Motor
Coupling
Cover
Canopy Screw
Cover
Figure 3
Clevis Pin
Hairpin Clip
Downrod
Support
Setscrew (2)
1. Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 5. (Figure 1)
▲ WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
3. Loosen the two setscrews in the downrod support.
Align the clevis pin holes in the downrod with the
holes in the downrod support. Install the clevis pin
and secure with the hairpin clip. Be sure to push the
straight leg of the hairpin clip through the hole near
the end of the clevis pin until the curved portion of the
hairpin clip snaps around the clevis pin. The hairpin
clip must be properly installed to prevent the clevis
pin from working loose. Pull on the downrod to make
sure the clevis pin is properly installed. (Figure 3)
4. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy with open side facing
up. (Figure 4)
5. Reinstall the hanger ball on the downrod as follows.
Route the three 80” wires and cable through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the setscrew in the hanger ball. A loose
setscrew could create fan wobble. (Figure 5)
NOTE: You will be using either the 4.5 ˝ downrod supplied
with your fan or an optional downrod purchased separately.
2. The fan comes with blue, brown and orange 80˝
Separate and untwist the three wires. Route
the wires the wires through the downrod.
wires.
(Figure 2)