ZSC-1000 User Manual.doc
Page 27 of 33
MEYERTECH LIMITED
Each site in the range 1 to 100 can be configured as a dialup site.
This works in combination with a dialup trunk (Input or Output trunk) setting. All sites set to dialup will share
the same dialup trunk(s).
Default = Off
MUX Ports
The ZSC-1000 routes commands out to ZVS-MSI units controlling MUXs. These units are normally
connected onto the ZVK port. However the ZSC-1000 can be configured to transmit these commands onto
another port.
For each MUX, in the range 1 to 90
Port
The port used to transmit MUX commands onto.
Default = Zvk
Enables
This section allows a number of miscellaneous features to be enabled.
Modification of any of these values should be done with care.
Uncontrolled Telemetry
If enabled telemetry is forwarded to the cameras without the requirement for control authentication.
Default = Off
No matrix polling
If enabled, the matrix on the ZVM port will not be polled for alarms.
Default = Off
24 hour alarms
If enabled the alarm handling is permanenantly enabled. An alarm disable command will effect only attached
alarm panels
Default = Off
ZSC-1000
