ZVK-66 User Manual
Issue 03
Page 7 of 17
Z
V
K
-
6
6
Network Setup
This is only required when the keyboard is connected directly to the ZVK network.
The ZVK-66 requires configuration of the following parameters before use:
•
MAC address
•
Termination
The Module Access code, or MAC is required to identify the ZVK-66 to its associated Fusion Workstation.
The baud rate is automatically detected. Valid rates are 9600, 19200 and 38400 bps.
Putting the Keyboard into configuration mode
This will only be required when the keyboard is connected directly to the ZVK network.
1. Power up the keyboard with the joystick button held down. The zoom and focus LEDs will light up and the iris
LED will indicate the toggling of the termination state.
2. The ZVK-66 will attempt to acquire a new MAC address. If no MAC is available, the keyboard will keep
searching until one becomes available.
3. Pressing the button on the joystick will toggle the termination setting (the state is displayed in Fusion).
4. When the settings are appropriate, follow the instructions from your Fusion Workstation
5. Cycle the power on the keyboard to complete the process.
