ZVK-66 User Manual
Issue 03
Page 6 of 17
Z
V
K
-
6
6
Configuration
The ZVK-66 keyboard has the usual system engineering parameters, which are normally configured by the engineer during
commissioning.
When the keyboard is connected direct to the Fusion workstation, the MAC and termination are automatically configured.
Please refer to the Fusion and FusionEdit manuals for how to setup Fusion to work with the ZVK-66 attached directly. Please
note that an RS422 adaptor is required for the workstation.
Possible Setups
Direct To ZVK Network
In this mode of operation, the keyboard must be configured to run on the ZVK network. The MAC address and
termination must be setup using the steps described below.
Connected Direct To Fusion
In this mode of operation the Fusion workstation should be supplied with an RS422 adaptor (in the form of a PCI card
or external module). The Fusion workstation is connected point to point with the keyboard and supplies all the settings
to the keyboard.
The keyboards MAC address is assigned in FusionEdit, and must match the MAC address of the port used on the
ZSC-250.
The only manual setup that may be required is the joystick calibration.
Note : In this mode of operation it is not possible for Fusion to connect to the PC2 port of the Site controller.
