Zonestar Z9 Series, Руководство пользователя

Страница: 50 / 57

Prepare to print - level the hotbed
50
Clean nozzle: make sure there aren't any filament at the end of nozzle, if not, remove it by a
diagonal pliers.
1
2
3
Choose “Prepare”>> “Auto Home”>>, wait the hotend go to the orig position.
Watch the nozzle and make sure the nozzle is higher than the bed, otherwise tighten the hand
nuts under the bed to pull down the hotbed or loosen these nuts to move up the bed.
4
Choose “Prepare”>> “Level Corners”>>, the nozzle will go to the first corner, adjust the hand
nuts under the hotbed, let the nozzle almost touch the hotbed. In order to get a properly
distance, you can put a A4 paper on the hotbed, and when the distanse between the nozzle
and hotbed can only insert a paper, it will be perfect.
Choose “next corner”, and adjust again. Repeat this step again and again, until all of the
four corner at the same height.
5
Home all axis
start “level
corners” wizard
Adjust bed
height
put a paper on the
bed to measure
the height