ZONE Medical Saver One T, Руководство пользователя

Страница: 9 / 14

User’s Manual
9
TRAINING PADS
The adhesive adult pads are for training use only. Use the pad cable for connecting pads to the unit and on
the manikin. Training pads can be re-used for several time with a correct maintenance:

Keep the adhesive side clean and free of dust. Stick pads with their original cover after each use.

Don’t wipe the adhesive side with paper and cloth

Don’t scrape the adhesive side with nail and brush.

Don’t store training pads in places subjected to direct sunlight, high temperature or humidity.
OPERATING INSTRUCTIONS

Connect the battery to the trainer unit. Status green LED will start flashing.

Keep ready the remote control: insert the 2 AA 1.5V batteries following the arrowhead direction.

Turn on the unit by pressing the ON/OFF switch (not available through the remote control – it only
turns off the unit).

The voice message “Place the two electrodes firmly to bare chest as shown in the picture” will be
issued until training pads are connected to the unit.
This message is not broadcasted if pads are connected before turning on the unit.
This message will be repeated for five (5) times after which the unit is turning off by itself, along
with a “beep” sound, if the pads are not connected.

Once pads are connected the unit starts with scenario #1 (S1).
Change scenario selecting from S1 to S10 on the remote control.
From the control section of the remote control, press buttons to: turn up or lower the volume
according to noisy in the class, select the second language (if optioned), pause the scenario if a
stop is needed for an explanation and play it again when finished.
From the events section of the remote control is possible to intercede at any time and in any
scenario to: simulate a bad pads connection condition, let the unit have a low battery or faulty
status, change rhythm from shock to non-shock, insist on doing CPR for the bitter end.
When the unit is simulating a faulty or low battery status (during scenarios S8, S9, S10 and with
troubles events generated by the user) the red LED will be illuminated as warning condition.

Switch off the unit with remote control OFF button or pressing the ON/OFF switch on the unit.