Zolux 487044, Руководство пользователя

Страница: 16 / 32

16
FR
EN
PL
NL
ES
PT
7/ Charging the battery:
1. Remove the rubber plug temporarily
and plug in the charger.
2. Plug the adapter’s power plug into a
standard AC wall outlet. The LED will
glow red.
3. When charging is finished the LED will
glow green. Unplug the adapter’s
power plug from the AC wall outlet and
disconnect the charger from the unit.
4. Place the rubber plug back in the
battery charging receptacle. The receiver/collar is still fully waterproof even if the rubber plug is
not closed, but place the rubber plug in the battery charging receptacle to make sure dirt does
not get inside. To charge multiple receivers/collars and a transmitter, combine additional
battery charger splitter cables as shown.
Warning: Fully charge the unit before using it for the first time. Do not charge the batteries near
any flammable substances. Fully charge the batteries if the unit is to be stored without use for a
period of one month or more. Always use Zolux approved chargers. If improper chargers are
used, the LED will flash in amber or may not light up at all.
8/ Code Setting:
1-Dog code setting
1. Start with the receiver/collar turned off and the Rheostat intensity dial level on the handheld
transmitter set to “0”. On the handheld transmitter, slide the dog selector switch left to align
with “I”.
2. Place the red dot on the back of the handheld transmitter to the red dot on the receiver/
collar. Hold the two red dots together for 5 seconds. Release them when the green LED blinks
rapidly on the receiver/collar.
3. With the handheld transmitter, press the Nick and Constant buttons simultaneously. The code
setting has been success fully done if the receiver/ collar vibrates when the pager button is
pressed on the handheld transmitter
2-Dog code setting
1. Start with the receiver/collar turned off and the Rheostat intensity dial level on the handheld
transmitter set to “0”. On the handheld transmitter, slide the dog selector switch right to align
with “II”.
2. Place the red dot on the back of the handheld transmitter to the red dot on the receiver/
collar. Hold the two red dots together for 5 seconds. Release them when the green LED blinks
rapidly on the receiver/collar.
3. With the handheld transmitter, press the Nick and Constant buttons simultaneously. The code
setting has been successfully done if the receiver/ collar vibrates when the pager button is
pressed on the handheld transmitter.