background image

U

SING

 

THE

 SurePower II Battery Pack

4

www.zoll.com

9650-000840-01 Rev. B

Displaying Battery Runtime

The 

SurePower II Battery Pack

can display its present status.

Note:

The 

SurePower II Battery Pack’s

 LEDs light 

only

 when the 

Display

 button is pressed.

To display the status of the SurePower II Battery Pack, press and 
release the 

Display

 button (momentary press) on the top of the 

battery.

When you press and release the 

Display 

button, all LEDs blink to 

indicate that they work. The battery then lights specific LEDs for 
approximately 10 seconds to indicate the battery’s runtime, calibration 
status, and fault state.

We describe what these LEDs indicate in the following sections.

SurePower II Battery Pack

 

Icon

LED Indications

This is the 

runtime indicator 

that displays the estimated 

runtime of the SurePower II Battery Pack in your defibrillator. 

When you momentarily press and release the 

Display

 

button on the SurePower II Battery Pack, the LEDs above 
these icons light for approximately 10 seconds to indicate 
the battery’s estimated run time. 

If the battery is fully charged, the LED over each of the five 
runtime indicator icons illuminates. As the battery 
discharges, the number of illuminated LEDs decreases.

As the SurePower II Battery Pack discharges, pressing the 

Display

 button will light, from left to right, the LED’s that 

indicate the battery’s run time. For example, if four LED’s 
light, the battery can power a defibrillator/monitor for at least
3 hours (displayed as 

3:00+

); if three LED’s light, the battery 

can power the defibrillator/monitor for at least 2 hours 
(displayed as 

2:00+

), and so on.

When you press the 

Display

 button on a battery that is 

installed and powering a defibrillator/monitor, the runtime 
indicator displays the run time for the battery in that specific 
unit.

When a SurePower II Battery Pack is not installed in a 
ZOLL defibrillator/monitor unit, the runtime indicator displays 
the runtime for the battery at a nominal drain rate for that
unit.

Note:

If the left-most LED of the runtime indicator blinks, 
the battery has less than fifteen minutes of use left, 
and defibrillator shutdown will soon occur. Recharge 
the battery as soon as possible.

Содержание SurePower II











Отзывы: