ZOJE ZJ9700, Руководство по эксплуатации

Страница: 36 / 86

- 31 -
1)The standard tilt(horizontal)of the feed dog is
obtained when marker dot A on the feed bar shaft
is aligned with marker dot B on feed rocker
①
2)To tilt the feed dog with its front up in order to
prevent puckedng,loosen the setscrew,and tum
the feed bar shaft 90 degrees in the direction of
the arrow. using a screw driver.
3)To tilt the feed dog with its front down in order
to prevent uneven matedal feed,turn the feed bar
shaft 90 degrees in the opposite direction from
the arrow
(Precaution) Whenever the feed dog tilt is adjusted,the feed dog height will be changed.So,it is
necessary to check the feed dog height after tilt adjustment.
1)The feed dog is factory-adjusted so that it just
out from the throat plate surface 0.75 to 0.85mm
For the heavy weight matedal,it just out 1.15 to
1.25mm
2)To adjust the height of the feed dog:
① Loosen screw ② of crank ①
②
Move the feed bar up or down to make
adjustment.
③
Securely tighten screw
②
.
1)The feed dog is factory-adjusted so that it just
out from the throat plate surface 0.75 to 0.85mm.
For the heavy weight material,it just out 1.15 to
1.25mm.
2)To adjust the height of the feed dog:
① Loosen screw ② of crank ①
②
Move the feed bar up or down to make
adjustment.
③
Securely tighten screw
②
.
21.2.Tilt the feed dog(Straight knife) (Fig.27.2)
22.1.Height of the feed dog (Round knife) (Fig.28.1)
22.2.Height of the feed dog (Straight knife) (Fig.28.2)