STEP 5
Piping
2) While
the discharge pipe, position and
mark the location of the pump unit discharge
Do not use a mechanical type vent.
3) Temporarily set the toilet in place to check that there
is no piping interference. Remove the toilet and set
it aside.
4) Clean, prime and solvent weld the discharge piping
and pump unit discharge
When
Cut cleanly and remove burrs and rough
applying solvent weld to discharge
ensure that none gets into the check valve assembly.
Pay close attention to the proper alignment of the discharge
previously marked above.
5)
Note: Adding other bathroom
- The Qwik Jon
®
Ultima is designed to accept additional bathroom
utilizing the two side inlets.
EA0064
© Copyright 2018 Zoeller Co. All rights reserved.
- 8 -
To maintain effective ventilation, please replace the
carbon filter periodically.
Available for connecting outside
diameter Ø32 mm or 1" pipe. Simply reverse the pipe
adaptor and cut out the molded-in plug at the provided
indentation.
Available for connecting outside
diameter Ø32 mm or 1" pipe.
Only need to reverse the pipe
adaptor.
Indentation
Check valve
Check valve
edges to avoid clogging.
.
1) Cut and
the pipe and
as required for
outside diameter Ø32 mm (1") diameter discharge
pipe (may be reduced to
outside diameter Ø25 mm
diameter
(3/4")
if codes permit).
Proper venting is required for the toilet to
Hand-tighten only for plastic nut. No wrench allowed.
If leakage occurs, please replace the o-ring.
