4
© Copyright 2010 Zoeller Co. All rights reserved.
Pump Wiring Instructions
FOR YOUR PROTECTION, ALWAYS DISCONNECT THE PUMP FROM ITS POWER SOURCE BEFORE HANDLING.
All electrical connections must be wired and grounded in accordance with the National Electrical Code and all applicable
local codes and or di nanc es.
“Risk of electrical shock”
Do not remove the power supply cord and strain relief or connect conduit directly to pump.
Installation and checking of electrical circuits and hardware should be performed by a qualifi ed licensed electrician.
FIGURE 3A. Models 810
and 815 Wiring Diagram
002397
10" MAX.
5" MIN.
FIGURE 2. Pump Control Switch Installation
Use the di a gram above to secure the fl oat switch properly and obtain the proper tether to cus tom ize the on-off cycle to each application. Note the
minimum off level shown above. On Prepackaged Systems, the tether length is set at 5”.
Note: Failure to keep within proper teth er limits
may pre vent reliable switch op er a tion.
Note: Cable must be mounted in hor i zon tal
position.
Determining Pumping Range
in Inches (1 inch - 2.5 cm)
Use only as a guide. Due to weight
of ca ble, pump ing range above
hor i zon tal is not equal to pumping
range be low hor i zon tal. Ranges are
based on test ing in nonturbulent
con di tions. Range may vary due to
water tem per a ture and cord shape. As
teth er length in creas es, so does the
vari ance of the pump ing range.
Tether Length (inches)
5 10
Pumping Range (GPM)
9 13.5
min.
max.
SK305D
SK2651
ALARM FLOAT
FLOAT TREE
MIN. OFF
16"
FLOAT
PUMP CONTROL
Electrical Data
Amps
KVA
Code
Winding
Resistance
Line-to-Line
Model
BHP
RPM
Voltage
Phase
Hertz
Full Load
Shut Off
Locked
Rotor
E810
1
1725
230
1
60
6.0
6.0
24.5
G
2.3 / 2.0*
E815
2
1725
230
1
60
10.5
10.5
44.0
B
1.80 / 1.60*
*Line to line reading from the electrical load will only refl ect the run winding resistance. Start winding resistance can only be measured after
removing the cover.
FIGURE 3B. Models 810
and 815 Wiring Diagram
(932 Replacement Grinder System)
018929
RUN
O.L.
MOTOR
(3)
BLUE
RED
GREEN
START
(1)
(2)
YELLOW
BLUE
RED
CAPACITOR
(WHITE)
(BLACK)
(BROWN)
RED
BLACK
WHITE