3
© Copyright 2012 Zoeller Co. All rights reserved.
1. Read all instructions before beginning installation.
2. Be certain that basin is on a firm level surface.
3. Do not use an automatic plumbing vent device.
4. Always use a check valve on the discharge line.
5. Test operation of pump per STEP 3.
Helpful Hints For Easy Installation
6. Always provide some means to disconnect basin from
plumbing for maintenance purposes.
7. Run unit at least once a month to verify proper operation.
8. The model number and date code can be found on the lid
warning label.
9. Plug pump into a properly grounded GFCI receptacle.
STEP 1
Determine Installation Configuration
NOTE: This preassembled unit is designed for use with an
external trap.
Figure 1 is a typical configuration for installation of the drain
system. The actual configuration will vary depending on your
cabinet and sink configuration.
Figure 1
STANDARD INSTALLATION
1. DO read all installation material included with the pump.
2. DO inspect unit for any visible damage caused by shipping.
Contact dealer if unit appears to be damaged.
3. DO always disconnect pump from power source before
handling. DO always connect to a separately protected and
properly grounded ground fault protected circuit. DO NOT
ever cut, splice or damage power cord. DO NOT carry or lift
pump by its power cord. DO NOT use an extension cord.
Do’s And Don't’s For Installing A Unit
4. DO NOT use
a discharge pipe smaller than the pump discharge
size.
5. DO test pump immediately after installation to be sure that
the system is working properly.
6. DO review all applicable local and national codes and verify
that the installation conforms to each of them.
Performance Characteristics
SK2001
015766
PIPING SHOWN ONLY
FOR CLARITY.
