User Manual
| 21 |
Connect the mains unit
Connect the terminals
Connect the limitation cable under
the charging station to the plus
connection! Connect a different
cable to the minus connection!
Apply the cover
Status messages/error messages
Re-start the robot
Place the robot on the boundary line
1.
Enter the safety code
2.
Push the start button
3.
Overcurrent at the cutting motor
Grass too high? ( > 4cm)? Cutting sleeve
blocked? Re-start the robot
E8
Error charging status
Malfunction of the battery. Re-start
the robot multiple times, if the issues persisits,
contact service.
E9
Over-/undercurrent of the robot.
Malfunction on the PCB bodard. Restart
the robot multiple times, if the issues persists,
contact service.
E10
Inclination in excess of 20 degrees? Re-
start the robot
Tilting sensor tripped
E11
Wheel slipping
Grass too high or too wet? Re-start the
robot.
E12
Overheating on battery
Wait for the battery to cool down.
Re-start the robot.
E13
Lifting sensor triggered
Rear wheel blocked or lifted? Restore
the rear wheel then re-start the robot.
E2
Robot outside of the boundary line
primeter.
Place robot inside, restart
E3
Boundary line cut
Red indicator LED flashes? Repair
-
boundary line, restart robot
E4
Grass too high? ( > 4cm)? Left wheel
blocked? Re-start the robot
Overcurrent on the left drive-motor.
E6
Grass too high? ( > 4cm)? Right wheel
blocked? Re-start the robot
Overcurrent on the right drive-motor.
E7
Emergency off actuated
Re-start the robot
E1
Robot does not start, signal
present
Robot is started outside of the boundary line or too far
from it? Restart the robot.
F1
Robot does not start, no signal
(charging station)
Boundary line/mains adapter correctly
connected?
F2
Collision sensor triggered
Obstacles? Re-start the robot
E5
Robot does not start
The power of robot mower is turned off previously?
Bring it onto the charging station and restart it.
F3
Battery voltage too low
Completely charge the robot
F4
EN
If the robot is turned off previously, it can only be
started on the charging station.
