User Manual
| 20 |
Initial setup
Please read safety instructions before setup. Check the appliance for completeness.
1
Place the charging station
Install the charging station
level and near a power
source!
Comply with distances and
alignment!
3
Fasten the charging station
6x
4
Place the boundary line
taut with the nails
Place the boundary line
< 2 - 3 cm in the ground!
Recommendation
: Place the
boundary line taut on the
lawn. The boundary line will
grow into the lawn.
< 0.7 m
150x
5
Remove the cover
Connect the mains unit
Correct installation
Defective installation:
(kink/interruption/loose
contact)
8
6
Place the wire in the
clamp and close it firmly
2x
Strip the boundary line
if necessary!
Connect the terminals
7
Connect the boundary line under
the charging station to the plus
connection! Connect a different
cable to the minus connection!
Consider at least 50 cm
reserve at the ends!
2
Place the boundary line
under the charging station
in a cable groove
Apply the cover
9
Completely charge the robot
before initial commission-
ing!
(red)
