Displayed when the vibrator function activated.
FM
Displayed when the FM is activated
RM
Displayed when the Room Monitor is activated
2. INSTALLATION
2.1 Removing the Belt clip
a. Pull up the belt clip latch from the ZD-360.
b. While pulling the belt clip latch, push up the belt clip as shown in Figure1.
2.2 Installing the Belt clip
a. Slide the belt clip into the slot as shown in Figure2.
A “click” indicates the belt clip is locked into its position.
2.3 Installing the Battery pack
Caution: Observe the proper battery polarity orientation when installing batteries. Incorrect positioning
can damage both the batteries and the unit.
a. Slide down the battery compartment cover.
b. Install the rechargeable battery pack by following the orientation as shown in Figure 3 (the arrow is
showing and pointing upward.)
c. Replace the battery compartment cover. See figure 4.
Important
Read these Safety Warnings before you charge the batteries.
When placing the ZD-360 in the charger, use only the power supplies listed in the user instructions
supplied with the ZD-360.
Don’t try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in place when you are charging the
batteries.
Dispose of used batteries safely and in a way that will not harm thecould get burnt or punctured.
Don’t leave dead batteries in your ZD-360 units. They might leak if you do.
Belt clip latch
Figure 1
Figure 2
Figure 3
Figure 4
