Zodiac Z550iQ, Быстрый старт

Страница: 23 / 184

22 23
7
Troubleshooting
• Before you contact the retailer, carry out these few simple checks using the following tables if a
problem occurs. If the problem is not resolved, contact your retailer
• : Actions to be performed by a qualified technician only.
❹
Troubleshooting
The appliance
does not start
heating straight
away
• When the water flow rate is zero or is not enough, the appliance stops: check that the water is
circulating correctly in the appliance and that the hydraulic connections are correct.
• The appliance stops when the outdoor temperature falls below -12 °C.
• If you have checked these points and the problem persists: contact your retailer.
The appliance
is discharging
water
• To check that the water is not coming from a leak in the pool circuit on the appliance, shut it
down and run the filter pump to circulate water in the appliance. If the water continues to flow
through the condensate drainage lines, there is a water leak in the appliance; contact your
retailer.
The evaporator
is iced over
• The appliance will soon switch to its defrost cycle to melt the ice.
• If the appliance cannot manage to defrost its evaporator, it will stop itself; this means that the
outdoor temperature is too low (below -12°C).
The appliance
is "smoking"
• If the appliance is not in its defrost cycle, this is not normal. Switch off and disconnect the
appliance immediately and contact your retailer.
The appliance is
not working
• If there is no display, check the supply voltage and the F1 fuse.
• When the water flow rate is zero or is not enough, the appliance stops: check that the water is
circulating correctly in the appliance.
The appliance
is working
but the water
temperature
does not
increase
• The operating mode is not powerful enough (appliance in «ECOSILENCE» or «SMART» mode).
Switch to «BOOST» mode and set the filtration to 24/24 manual while the temperature rises.
• Check that the automatic filling valve is not stuck in open position; this will keep supplying cold
water into the pool and will prevent the temperature from rising.
• There is too much heat loss as the air is cool. Install a heat insulated cover on the pool.
• The appliance is unable to capture enough calories as its evaporator is clogged with dirt. Clean
it to restore its performances
• Check that the appliance is the right size for this pool and its environment.
The fan is
running but
the compressor
stops from time
to time with no
error message
• If the outdoor temperature is low, the appliance will perform defrost cycles.
• The appliance is unable to capture enough calories as its evaporator is clogged with dirt. Clean
it to restore its performances
The
appliance,trips
the circuit
breaker
• Check that the circuit breaker is correctly dimensioned and that the cable section used
is correct.
• The supply voltage is too low; contact your electricity supplier.
Appliance behavior
To get the full list of errors, consult the online manual.