H0493700.A - EN - 2014-07
6
•
Click the 2 parts of the POD Kit collar together around the pipe. For a Ø50 mm pipe, use the
reducer labelled 'EU'. Do not use this reducer for a Ø63 mm pipe.
• Position the upper part of the POD Kit with its various components in the direction indicated
by the foolproof locating notch and tighten the locking ring firmly (hand-tighten only).
2.3.1 Installing the pH and ACL sensors
• Carefully unscrew the protection cap from the sensor (
1
).
• Rinse the end of the sensor with tap water and shake off excess water.
Never wipe the sensor using a cloth or paper tissue, as this may damage it!
•
Screw the sensor into the threaded hole on the POD Kit until the O-ring seal on the sensor
comes in contact with the POD kit (
2
). Do not use excess strength. If necessary, use the
supplied Teflon band.
•
Connect the supplied BNC cable to the top of the sensor.
Do NOT screw/unscrew the sensors while they are still connected to their BNC
cables. Disconnect the cables beforehand to avoid damage.
•
Once the sensors are installed they may be connected to the BNC sockets on the power
pack named " pH" (blue) and "ACL" (red). They must now be calibrated (see § 3.3).
1
2
A badly-installed sensor may give false readings and cause inappropriate operation of the appliance. Neither the
manufacturer nor the unit shall be liable in this event.
1
2
Identify a suitable length (minimum 30 cm, without elbow) of
straight pipe.
•
Dismantle the POD Kit and keep the lower part with 2 holes (
1
).
•
Turn the lower part of the collar upside down and place it in the
position where you want to install it on the pipe.
• Use a center-punch or marker pen to mark the position of the
holes to be made in the pipe (
2
).
•
Using the holes saw supplied, cut the 2 feed holes for the POD Kit.
Ensure that the edges of the holes are smooth and deburred!
•
Place the upper part of the POD Kit on the pipe, sliding it into the previously-drilled holes.
The arrows on the upper part of the POD collar show the direction of water flow.
Reducer (labelled
“EU”) Ø50 mm
Collar Ø63
