10
H0491600.C - EN- 2015-12
3.6 I Ending the cleaning cycle
• Do not pull on the cable to remove the device from the pool. Use the handle.
• Do not leave the device to dry out in sunlight aft er use.
• Store all the elements away from sunlight, dampness and bad weather.
• Screw the protecti ve cap back on if you unplug the control box power cord.
• Switch off the device by pressing
..
• When the cleaner is within arm's reach, pick it up by the handle and lift it gently out of the pool so that the water it
contains drains into the pool (see image )
• Place the cleaner verti cally at the locati on provided on the trolley (depending on the model) for it to dry out quickly
(see image )
.
• Then store it with the command box away from sunlight and any splashing. A protecti ve cover is available as an opti on
(see image )
.
3.6.1 "Out of water" mode
(depending on the model)
This functi on enables the cleaner to be returned to an exact point at the edge of the pool. When it climbs the wall, the
cleaner sprays a jet of water behind it to make it lighter as it exits the pool.
• Direct the cleaner towards the wall you want, then have it climb the waterline: hold down
to ti lt it. The cleaner
moves towards the wall when you release the butt on.
Tip: prevent the fl oati ng cable from becoming too entangled
The cleaner's behaviour is strongly impacted by the tangling of the cable. A cable which is correctly untangled
will guarantee bett er coverage of the pool.
• Untangle the cable and lay it out in the sun so that it returns to its original shape.
• Then wind it up carefully and place it on the trolley handle (depending on the model) or on a fi xed
support.
EN
