Zodiac Vortex 3.2, Инструкция по установке и эксплуатации

Страница: 7 / 16

H03839
‐
00.B2 EN – 2013
‐
09
6
3.2 Choice of a cleaning cycle

On first use a default cleaning cycle is programmed. The indicators below are on:

Vortex ™ 3.2, Vortex ™ 3 4WD:

Vortex ™ 4 4WD:

In order to customise the cleaning cycle , use the following buttons (see § 2):

Vortex ™ 3.2, Vortex ™ 3 4WD:

Vortex ™ 4 4WD:
3.3 Removing the cleaner from the water
You can use the “remove from pool” mode during the cleaning cycle or at the end of the cycle by using the
control box or the remote control (Vortex™ 4 4WD).

Using the control box , a short press on the button. The message is displayed (Vortex™ 3
4WD, Vortex™ 4 4WD). The cleaner moves towards a pool wall and climbs up to the waterline.

Using the remote control unit (Vortex 4 4WD) : (see § 5.1).
‐
When the cleaner is within hand's reach pick it up by the handle and lift it gently out of the pool so that the
water it contains drains into the pool (1).
The cleaning cycle can be customised at any time, before the cleaner starts or while it is operating. If you
customise the cycle during operation, the new cycle will be launched instantly and the remaining time
countdown will be reinitialised.
To remove the cleaner from the pool at a specific location BEFORE pressing the “remove
‐
from –water” mode

Using the control box :
‐
Press the button on the control box to make the cleaner turn to the left and to direct it in the
desired direction. The message is displayed (Vortex™ 3 4WD, Vortex™ 4 4WD).
‐
The cleaner advances until you release the button

Using the remote control unit (Vortex 4 4WD) : (see § 5.1).
Don't pull on the cable to remove the cleaner from the pool. Use the handle.
Low intensity
Bottom
Other shapes, other
Bottom
