13
CONNECTING TO A CONTROLLER
3. Remove the lower cover from the
TRi unit.
NOTE: If using either pH upgrade or PRO unit –
carefully disconnect the ribbon cable from the TRi unit.
4. Remove the small white bung closest
to the centre of the lower panel of the
TRi unit.
5. Thread the controller cable through
the hole (a grommet may be necessary
depending on the size of the cable
being used).
6. Attach a cable tie to the controller
cable as shown in the diagram.
The wiring colour coded are outlined
below:
Depending on the make of the Controller, make the following wiring
connections:
Polaris EOS/ Jandy Aqualink
Green wire (0V) to ‘0V’ terminal on the TRi
Red wire to the (+V) ‘POS’ terminal on the TRi
Yellow/White (B) wire to ‘B’ terminal on TRi
Black wire (A) to ‘A’ terminal on TRi
Pentair Intellitouch
GREEN wire to ‘B’ terminal on TRi
Red wire to ‘POS’ terminal on TRi
Yellow wire to ‘A’ terminal on TRi
Black wire to ‘0V’ terminal on TRi
