Zodiac SIROCCO 2 2M, Инструкция по установке и эксплуатации

Страница: 16 / 32

15
Electric heater Electric heater heating / Electric heater off
Circulator (hot water coil
option)
Circulator on / Circulator idle
Alarm Alarm in progress / /
Celsius
Appliance configured
to measure in degrees
Celsius
/ /
“Manual” mode
Programming using
“manual” mode.
/ /
Humidity level percentage
Appliance configured as
a humidity sensor
/ /
3.2 I Operation
3.2.1 Switching on the appliance
• Power on the appliance (by switching on the general terminal board),
• The program version remains visible for 5 seconds then "OFF" and "KEY" is displayed before the appliance starts.
Only on Sirocco 5T models (three phased):
• This operation must be only be carried out by a qualified professional.
• The phase order controller protects the compressor. It is forbidden to invert phases:
- On the power contactor.
-
On the compressor.
• When the dehumidifier is switched on, check the status of the phase order controller as shown below:
Indicator light
status
OK~ OK~
• If there is a phase inversion or missing phase:
1. Disconnect the appliance from the power supply;
2. Invert two phases directly on the appliance connection terminal board;
3. Restore power to the appliance and check the status of the indicator lights.