EN
H0426500.B EN - 2015/02
10
6.2 Other possible situations
PROBLEMS
SOLUTIONS
While operating, the cleaner does
not stay firmly on the pool bottom
This may have 3 causes:
• There is still air in the casing of the appliance. Repeat the cleaner immersion
operations (see § 1.5).
• The filter is full or dirty: all you have to do is clean it.
•
The propeller is damaged:
contact your reseller
The cleaner does not or no longer
climbs the pool sides
This may have 2 causes:
• The filter is full or dirty: all you have to do is clean it.
• Even though the water seems clear, microscopic algae are present in your
pool, they are not visible to the naked eye, and they make the sides slippery
and prevent the cleaner from climbing. Carry out shock chlorination and slight-
ly reduce the pH.
Do not leave the cleaner in the water during shock treatment.
The cleaner does not perform any
movements on start-up.
• Check that the outlet to which the control box is connected is receiving a
power supply.
• Check that you have started a cleaning cycle and check that the indicators are
on.
If the problem continues contact your reseller.
The cable gets tangled
• Do not unroll the entire length of the cable into the pool.
• Place the required length of cable in the pool and place the rest on the side of
the pool.
The control unit does not respond
when you press the buttons
• Unplug the cable from the mains socket, wait 10 seconds and plug it back in
again.
==> If the problem continues contact your reseller.
7. Registering the product
Register your product on our website:
• You will be the first to be informed of new Zodiac® products and special offers,
• You can help us to constantly improve our product quality.
Europe & Rest of the World
www.zodiac-poolcare.com
America
www.zodiacpoolsystems.com
Australia – Pacific
www.zodiac.com.au
8. Product conformity
This appliance has been designed and built according to the following standards:
Low voltage directive:
2006/95/EC
Electromagnetic compatibility directive:
2004/108/EC
EN 55014-1: 2000 +A1:2001 +A2:2002 ; EN 55014-2: 1997 +A1:2002
EN 60335-1: 2002 + A1:2004 + A2:2006 +A11:2004 + A12:2006 ; EN 60335-2-41: 2003 + A1:2004
Relative to which it is compliant. The product has been tested under the normal conditions of use.
SAFETY STANDARDS:
The cleaners are classified by the ETL as being compliant with the appropriate requirements of IEC 60335-2-41.