Zodiac PF Premium 11T, Инструкция по установке и эксплуатации

Страница: 9 / 22

H03620
‐
00.D2.EN – 2013/03
8
3.1.2 Locking and releasing the key pad
Press and for 3 seconds: or
3.2 Starting the device

check that no tools or other objects have been left inside the device,

the access door for technical components must be fitted,

set the by
‐
pass and setting valves (see § 2.4) as follows:
-
valve 1 completely open,
-
valves 2
‐
3
‐
4 & 5 closed.
An incorrect setting of the by ‐ pass valve may lead to device malfunction

switch on the filter system,

progressively close valve 1 in order to increase the filter pressure to 150 g (0.150 bar) ,

open valves 2, 3 and 4 completely, then half open valve 5 (see §2.4) (the air accumulated in the heat pump
condenser and in the filter circuit is then bled),
If valves 4 and 5 are not fitted, open valve 1 completely, and half close valve 3.

power
‐
up the heat pump,

if the heat pump is on stand
‐
by: , press on for 3 seconds, will appear
for 2 seconds, and for 3 seconds, and the water and set
‐
point temperatures will be displayed:
, a 2
‐
minute delay will start,

set the required water temperature:
-
press to increase temperature,
-
press to decrease temperature,
When the pool reaches the required temperature, the heat pump will automatically stop.

set the water flow
‐
rate using the menu , when the indicator is steady: press to display the water
flow
‐
rate status:
Status water flow ‐ rate ok no water flow water flow ‐ rate too weak water flow ‐ rate too strong
Display

set the flow
‐
rate using valve 5 (or 3 if no valve 5 is fitted), and, to quit the menu, press .
During this adjustment phase, wait for a few minutes after each change in valve position to allow the
device to balance.
3.3 Checks to perform after start ‐ up
The heat pump must stop when:

the set
‐
point temperature is lowered using the digital control panel,

filtering is stopped or valve 2 or 3 is closed 3,

the digital control panel is turned off by pressing ,