10 / 14
QUICK INFLATION SYSTEM
•
Connect the couplings to the tips of hoses (4 and 7) on the 3 quick couplings (8 and 3) by
pushing the hose into the connector.
Check that tips (5) of hoses (4 and 7) are properly screwed to the regulator (6).
•
Screw the regulator (6) to the diving bottle (1).
•
Place the bottle (1) back into its casing on the transom. Close the quick-release fasteners
and tighten the fixing straps.
•
Check that the inflation system assembly of the boat is in quick inflation position:
−
Caps of the overpressure valves must be removed,
−
Inflation valves of the bottom and buoyancy tube must be screwed on and the caps
closed,
−
The keel inflation hose connectors must be locked,
−
Arrow of I/C valve inserts must be in "GONFLEMENT"(inflation) position.
•
Fold the boat starting from the bow towards the transom.
Close the respirator haversack.
INFLATION – NAVIGATION
Illustration in Appendix of page A-9
•
Open the bag and slightly unroll the transom in order to reach the valve of the diving bottle.
•
Open wide the valve of the bottle. Stay close by in order to re-shut off the valve if necessary.
•
Allow the boat to inflate until all the overpressure valves open Re-shut off the valve of the
bottle.
•
The boat is ready for navigation:
−
Screw the caps to the overpressure valves,
−
Position the arrow of I/C valves on "NAVIGATION",
−
Disconnect the keel inflation hose.
warning
DURING QUICK INFLATION, CAPS OF OVERPRESSURE VALVES
MUST BE REMOVED AND THE VALVES PUT IN “GONFLEMENT”
(INFLATION) POSITION.
STOP THE INFLATION IMMEDIATELY IF THESE CONDITIONS ARE
NOT MET.