3/16
THE INFLATION SYSTEM
The inflation system consists of:
THE INFLATION PUMP
(a) Adapter
(b) Hose tip
(c) Hose base
(d) Air outlet
To inflate:
•
Place the hose tip in the air outlet,
•
To inflate correctly, the pump should be flat on
the ground,
•
The boat will inflate rapidly if pumping is done
at a regular calm rhythm,
•
Use the adapter that corresponds to the
diameter of the hose tip valve.
INFLATION VALVE IN THE BUOYANCY TUBE AND KEEL
Inflation position
Deflation position
Valve closed, the inner button springs
upwards.
Valve open, the inner button pushes
down and twists to the left.
INFLATION VALVE IN THE HIGH PRESSURE FLOOR
(1) Cap (2) Valve insert (3) Valve base
To activate the valve in the inflation position:
•
Remove the valve from its protection,
•
Unscrew the cap,
•
Screw the valve into its base (tighten fully
without damaging the thread), keep the cap
at hand.
To close the valve after inflation:
•
Screw on the cap.
To deflate the buoyancy tube: Unscrew the
valve from its base.
NOTE
:
ALWAYS REPLACE VALVE CAP AFTER INFLATING OR DEFLATING
1
2
3
High-pressure
inflation pump
(Bravo 9)