Page 15
Page 14
EL Series Saltwater Chlorinator | Installation Manual
Section 11. Troubleshooting
When there is an error condition, “ERROR” flashes on the display along with the error code.
Fault Indication
Possible Cause
Solution
NO FLOW
►
Pump turned off/disconnected or valves
closed
►
Blue wire disconnected from cell
►
Ensure valves/pump ON
►
Connect BLUE sense wire to cell
LOW SALT
►
Salt level in pool has dropped too low
►
Pool water temperature is low
►
Cell has calcified
►
Cell has failed
►
Take sample of water to retailer and check salt level - add
salt as recommended.
►
Add salt and turn chlorinator output down until the water is
warmer.
►
Clean the cell.
►
Call for service
Display Blank
►
No power to controller
►
Fuse blown
►
Plug in controller and ensure main power available
►
Have a service technician replace fuse (2A slow blow)
Low/No Chlorine
in pool
►
Cables not connected to cell
►
Timer period too short
►
Chlorine output level too low
►
Filter needs backwashing
►
Ph too high
►
Pool stabiliser (cyanuric acid) too low
►
Salt level too low
►
Connect cables
►
Increase timer period (particularly during summer)
►
Increase chlorine output
►
Backwash filter
►
Balance pH level to 7.4 - 7.6
►
Increase stabiliser between 30 - 60 ppm.
►
Increase salt to above 6000 ppm
Clock loses time when main
power is removed
►
Clock power backup failed
►
Call a technician
Timer is set to OFF in the
TMR menu
►
The timer has been turned off
►
Use
to turn the timer back on. Adjust timer start and
stop times to suit.
Table 5. Troubleshooting
