Your CYBERNAUT™ has been manufactured
in compliance with the strictest standards.
To get the most out of your appliance in complete
safety, treat your appliance as follows:
• Only connect the control box to an earthed electrical socket fitted with a
maximum 30 mA residual current protection device.
• Take sure the control box is at least 3.5 metres from the edge of the pool
and do not expose it to direct sunlight.
• Never let anyone bathe in your pool while your robot is in the pool.
If the transport trolley should accidentally fall into the water, it is imperative
that you disconnect it from the electricity supply before rescuing the trolley.
• To prevent any risk of electric shock, never open the electronic control box.
Call in a qualified technician.
• Never try to repair the mains electricity cable. Contact the After Sales Service
to have it replaced with a genuine spare part to prevent hazard.
1. The robot does not run along
the bottom of the pool properly.
There is air inside the body of the appliance. Repeat the initial immersion
procedure making sure you carry out the steps described earlier point by point.
Turn the robot right over keeping it immersed so the air trapped inside the body escapes.
Press the foam pads well to push out the air.
2. The robot does not mount or
no longer mounts the sides.
There can be 2 reasons for this:
- The filter bag is full or clogged. Simply clean it.
- Although the water looks clear, there are microscopic algae in your pool not visible
to the naked eye, which are making the sides slippery and preventing the robot
from climbing. Carry out a chlorine shock-treatment and reduce the pH slightly.
Never leave the robot in the water during a chlorine shock-treatment.
N.B. : failure to climb the sides will not have a major effect on cleaning which is
primarily done over the bottom of the pool. Since the CYBERNAUT™ can turn,
it will still clean the whole of the bottom surface.
3. The robot does not move at all.
Make sure there is electricity being supplied to the socket to which the control box is connected.
Make sure you have:
- set the "On(I)/Off(O)" switch to On (I),
- pressed the "start" button,
If you have selected manual mode, check that the button controlling the direction
of movement is set to forward or back and is not in the middle position.
If the problem persists, contact your retailer.
4. Cleaning efficiency seems to have reduced.
Check that the foam pads have not become smooth.
As a rule, it is advisable to replace the foam pads after one season's use.
31
30
3.
If you have
a problem...
Your safety
4.