![background image](http://html1.mh-extra.com/html/zodiac/cx35/cx35_owners-manual_4028170015.webp)
4.4 Replacing the Brushes
The cleaner is fitted with PVC brushes in front and
rear. There are ''wear'' indicators (Figure 26) on the
brushes. To maintain cleaner performance at its best
you need to replace the brush matt as soon as one
of the wear indicators has been reached (even if the
bristle wear is not even). Zodiac Group Australia Pty
Ltd recommends that you replace the brushes every
two (2) years.
Figure 26. Wear Indicators
1.
Stand the cleaner on its end in a vertical
position (Figure 27).
Figure 27. Stand Cleaner Upright
2.
Separate the edges of the brush, undo the tabs,
and remove the worn matt.
3.
Position the new brush matt underneath the
roller with the bristles facing downwards.
Refer to Figure 28.
Figure 28. Position the New Brush on Roller
4.
Thread each tab into the slot provided and
gently feed it through until the heel comes out
at the other side of the slot. Refer to Figure
29.
4
Figure 29. Pull Tabs Through Each Slot
5.
Use scissors to cut the tabs at the guides, as
shown in Figure 30.
Figure 30. Cut Tabs
6.
Repeat this procedure to replace the second
brush matt.
15
H0574000_REVA