8
Operation
❶ Installation
❷ Use
Connecting to the iA app
Open the hydraulic circuit
•
Close valve B gradually.
•
Open valves A, C and D fully. Open valve E by half (the air built up in the condenser and the filtration circuit
will bleed out). If valves D and E are not present, open valve A wide and close valve C by half.
•
Connect the power supply to the heat pump.
•
If the heat pump is on standby, press
for 3 seconds; the splash screen appears for 4 seconds then the
main screen is displayed. A 2-minute timer will start.
•
Set the desired temperature.
The heat pump can be remotely controlled from a smartphone or tablet, via the iAqualink
+™
app available for
iOS and Android systems. Before connecting to the iAqualink
+™
app, ensure that you:
•
Use a Wi-Fi-enabled smartphone or tablet.
•
Use a Wi-Fi network with a reasonably strong signal when connecting to the heat pump: the Wi-Fi signal
must be detectable at the place where the appliance is used. If this is not the case, a technical solution
must be provided to amplify the existing signal.
•
Rest close to the appliance and have your home Wi-Fi network password at the ready .
Download the
iA™ app
+
Press and hold
The screen
displays «bLE’’
Click on
on the
mobile device to
add the appliance
Name the
appliance
CAUTION : An incorrect
by-pass setting may
cause the heat pump to
malfunction.
Mobile
device
Home Wi-Fi
network
Heat pump
5
Содержание AquaLink Z350iQ
Страница 79: ...79...
