10
3.5 I Starti ng and stopping a cleaning cycle
To prevent risk of injury or property damage, be sure to adhere to the following:
• Bathing is prohibited while the device is in the pool.
• Do not use the device during a shock chlorinati on. Wait unti l the chlorine level has reached
the recommended value before immersing the cleaner.
• Do not leave the device unatt ended for an extended period.
• Do not use the device if the rolling cover is closed.
•
When there is power to the control unit, the following symbols light up to indicate:
-
The acti on in progress
-
The cleaning selected
-
Maintenance required
•
The control unit switches to standby aft er 5 minutes, the screen and LED switches off . Simply press a butt on to come
out of standby. Standby mode does not stop the device operati ng if it is in a cleaning cycle.
3.5.1 Choice of cleaning mode
•
By default,
Smart mode
is the pre-set cleaning mode (cleaning the fl oor, walls and waterline over an opti mised period
of ti me depending on the pool's dimensions).
•
During the fi rst cycle launched in Smart mode, the cleaner explores the pool while cleaningfor a cycle lasti ng 2 hours
and 30 minutes. During this fi rst cycle, the control box displays "AUTO / 2h30" (depending on the model). At the end
of this cycle, the opti mum cleaning ti me is calculated.
•
This opti mum cleaning ti me is then saved and becomes the default cleaning ti me for future cycles launched in Smart
mode. The control box then displays the opti mum ti me calculated.
•
To reset Smart mode, press and hold the butt on
for 5 seconds Launch a new cycle in Smart mode so that the
cleaner recalculates the opti mum cleaning ti me.
•
The cleaning cycle can be modifi ed before the device starts or while it is operati ng. The new mode will be started
immediately and the remaining ti me from the previous cycle will be canceled.
• Press
:
- Quick Mode (Quick cleaning bott om only):
- Smart Mode (Opti mised cleaning of the bott om, sides and water line):
- Ultra mode (Intensive cleaning the bott om, sides and water line):
(in accordance to the model)
- Water line mode only:
(in accordance to the model)
• Press
to start the cleaning cycle.
Tip: to improve cleaning performance
At the start of the bathing season, run a few cleaning cycles in bott om only mode (aft er removing any large
debris with a net).
Regular use of the cleaner (not more than 3 ti mes a week) will keep your pool permanently clean and the
fi lter less clogged.
3.5.2 Adjusti ng the cleaning ti me (depending on model)
•
You may reduce or increase the ti me for the cleaning cycle selected or in progress:
-
:
Reduce by 15 minutes.
-
:
Increase by 15 minutes.
EN