Figure 13. Skim (Half-moon) Sensor Retrofit
Installation
Figure 14. Slip Sensor Installation
Cable
Mount Sensor with Velcro
Sensor
Sensor
Existing Water Level
Cable
Do Not Submerge
Sensor Under
Water
TOP VIEW
SIDE VIEW
Cable
Sensor
Sensor
Water Level
Do Not Submerge
Sensor Under
Water
TOP VIEW
SIDE VIEW
Coupling
Extension
Pipe
Cable
Sensor Tips
3.6 Installing the Sensor
NOTE If using a dual style sensor, cut off and discard
the sensor you are not planning to use. See
Figure 12.
CAUTION
Important Safety Instructions.
Sensor wires
must be continuous and not spliced. Solder all
low voltage wire connections when possible and
always use grease-filled wire nuts on low voltage
connections.
1. Install the sensor in the appropriate location for the
sensor style.
a. Mount the skim (half-moon) sensor horizontally
to an existing skimmer. Mount with velcro or a
suitable adhesive in the skimmer throat behind the
whir door arc. See Figures 13 and 15.
b. Mount the slip sensor vertically in a static pipe.
Glue the sensor to the coupling.
See Figures 14 and 16.
NOTE Screw the optional threaded sensor into a 1"
threaded coupling.
NOTE When using the static pipe method, glue all
1” fittings only. Do not glue 2” fittings. Glue all
fittings with proper ABS/PVC glue: 793 IPS
brand for ABS/PVC.
2. Connect the sensor wires as follows:
Models K-1100, LX2, and LEV110CK/2G:
Connect the sensor cable to the two (2) orange
wires in the control box using wire nuts. See
Figures 3 and 6.
Model K-2300
:
a. Connect one (1) wire from Sensor I and one
(1) wire from the Sensor II to the yellow Sensor
Common wire using wire nuts. See Figure 9.
b. Connect the other wire from Sensor I to the
yellow wire with the blue stripe using wire nuts.
See Figure 9.
c. Connect the other wire from Sensor II to the
yellow wire with the red stripe using wire nuts.
See Figure 9.
NOTE For all models, the wire to the sensors must be
continuous. There cannot be any wire splices.
Skim Style
Slip Style
Figure 12. Dual Style Sensor
Page 12
ENGLISH
Jandy Pro Series Levolor
®
Electronic Water Leveler
Models K-1100, LX2, K-2300, and LEV110CK/2G
|
Installation and Operation Manual
