Zmotion ZMC308E, Руководство пользователя

Страница: 29 / 63

ZMC308E Motion Controller Hardware Manual V1.5
→ Wiring Note:
⚫
The wiring principle of high-speed digital output OUT (0-3) and low-speed digital
output OUT (4-11) is shown in the figure above. The external signal receiving end can
be an optocoupler or a relay or solenoid valve, as long as the input current does not
exceed 300mA.
⚫ For the connection of the common terminal, please select the "EGND" port on the IO
terminal to connect to the negative pole of the DC power supply of the external input
device. If the DC power supply of the external device and the controller power supply
are in the same power supply system, this connection can also be omitted.
⚫ The E5V port is a 5V power output port, which can be used when facing some loads
that need to provide an external 5V power input, with a maximum current of 500mA.
3.5.2. Basic Usage Method
(1) Please follow the above wiring instructions for correct wiring.
(2) After power on, please use any of the three interfaces ETHERNET, RS232 and RS485
to connect to ZDevelop.
(3) Terminal can be operated to ON or OFF directly through “OP” command, also, it can
be opened or closed through “ZDevelop/View/Op”. Please refer to “ZBasic” for details.