Zmotion XPLC3264E, Руководство по оборудованию

Страница: 26 / 28

XPLC3264E Controller Manual
20
Chapter Four common problem
prob
lem
Suggestions
for solving
problems
The motor does not rotate.
Confirm that the ATYPE configuration of the
controller is correct;
Confirm whether the pulse sending mode and the
input pulse mode of the driver match; Confirm
whether there is hardware limit, software limit,
and ALM signal function; You can use the test
software to test and observe whether the pulse
count is normal;
The controller has been
working normally, sending
out pulses normally, but
the motor does not rotate.
Check whether the connection between the drive and
the motor is correct, the drive and the controller
Whether the wiring between them is in good
contact.
Make sure that the drive is working properly and
there are no alarms.
The motor can rotate,
but it is not working
properly. Check whether the set deceleration and speed exceed
the equipment limit;
Check whether the output pulse frequency exceeds
the receiving limit of the driver;
Check whether the controller and the driver are
properly grounded, and whether the anti-interference
measures are done well; The current limiting
resistor used in the photoelectric isolation
circuit at the output terminal of the pulse and
direction signal is too large, and the working
current is too small.
Can control the motor, but
the motor appears
Oscillation or overshoot.
It may be that the driver parameter settings are
not correct, check the driver parameter settings;
The acceleration and deceleration time and movement
speed settings in the application software are
unreasonable.
Can control the motor, but
when working, return
The origin positioning is
not allowed.
Whether the origin signal switch is working
properly;
Whether the origin signal is disturbed.
Limit signal does not work. The limit sensor is not working properly;
The signal of the limit sensor is disturbed;