ZM Bombas ZM 44 MAXXI, Инструкция по эксплуатации

Страница: 6 / 7

Maximum elevation: 150m
Maximum elevation: 150m Maximum elevation: 130m
Possible defects, causes and solutions
Problems Causes Solutions
The wheel turns and stops Water flow insufficient to drive the
wheel.
Increase the water volume to move the wheel or change the stroke
of the pistons. *
The pump functions but does not
propel water 1) Grit/obstructions in the valve
2) Air intake
3) The propulsion tube is cracked
1) Clean the suction tube and place a nylon screen (mosquito
net type), in front of tube
2) Clean the valve, remove obstructions
3) Check the connections at the top and base of the suction
tube, eliminating any possibility of air intake
4) Adjust the leather seals by moving the lateral part of the
leather assembly, or replacement
5) To test the pressure of the pump, close the exit. If you have
an reduction (stop) of the rotation of the wheel, the different
closing of the pump are corrects, in this case the tube is
fissured. In this case that the wheel does not stop stop,
check the valves and the leathers of the pump
The pump doesn’t suck water
1) The level difference between the
pump and the water to be lifted is
higher than 7 meters.
2) Problem in the valves
3) Degraded leathers
4) If water to be lifted is higher than
the level of the pump, the water
enters the pump with an abnormal
pressure, closing the suction valve
1) Instal a vertical non return valve and prime the tube with
water before use
2) Verify that the valves are not blocked
3) Change the leather seals
4) Bring water in a tank near of the pump and make the suction
in this tank.
The pump pumps in a jet 1) Valves blocked
2) Degraded leather seals
1) Verify that the valves are not blocked
2) Adjust leather seals
Production (flow) insufficient of the
pump 1) Degraded leather seals
2) Water flow to the wheel is
insufficient
3) Valves out of alignment
4) Water availability limited
1) Change the leather seals
2) Verify if the water production is suitable for the wheel
rotation
3) Change the valves
4) Find another water source
* See the instruction on the pistons stroke modification – pg ?
ZM 63 MAX 1
Production by revolutions and pump stroke
Stroke
20 r.p.m. 30 r.p.m. 40 r.p.m. 50 r.p.m. Elevation
Extra
17,300 25,900 34,600 43,300 100m
Normal 14,500 21,800 29,100 36,400 110m
A
12,700 19,100 25,500 31,900 120m
B
10,900 16,400 21,800 27,300 130m
C
9,000 13,600 18,200 22,700 140m
D 6,300 9,500 12,700 15,900 150m
ZM 95 MAX 1
Production by revolutions and pump stroke
Stroke
20 r.p.m. 30 r.p.m. 40 r.p.m. 50 r.p.m. Elevation
Extra
48,900 73,400 97,800 – 90m
Normal 42,800 64,200 85,600 107,000 100m
A
36,600 55,400 73,900 92,300 110m
B
30,500 45,700 61,000 76,200 120m
C
24,200 36,700 48,900 61,100 130m