Zline RBIV-30, Руководство по установке

Страница: 7 / 44

CABINETS
Make sure that the cabinets where you will install the appliance has been safely mounted in
your kitchen. Your cabinets must be connected to the floor and the wall properly and with
suitable connections.
For the best installation, clearances between the cabinets and the product must be in
compliance with the values specified in the installation instructions.
Side walls must be free of clearances and their surfaces must be flat. Minimum thickness of
the side walls is 5/8" (16 mm).
Note: Minimum thickness of the doors to be attached to the product must be ¾" (19 mm).
ATTENTION
Failure to follow these instructions may result in death, fire or electric
shock. Connecting the grounding conductor of the equipment to an
improper place may lead to electric shock. Please have the grounding
checked by a qualified electrician or service technician if you have any
doubt about the proper grounding of the product.
Installation, repair and other procedures performed by unqualified
persons may cause danger. Before installing the appliance, make sure
that the voltage, load and circuit current parameters on the data plate
are in compliance with the power mains in your house.
The appliance is provided with a NEMA 5-15 P plug and a 3-pin
power cable which is in the UL list and ready to be connected to a 120
V, 60 Hz power supply. Fuse is 15 A. The appliance must be connected
to an electrical outlet receptacle. The plug must be installed only by a
licensed electrician.
If the electrical wiring or the electric power supply of the house needs
alteration, the necessary procedures must be performed by a qualified
electrician.
ATTENTION
Do not install your refrigerator:
• In open areas
• In environments where water is dripping
• In environments where temperature is lower than 61° F (16°C)
VENTILATION
Vent panels where the air enters and exits the unit must not be blocked or obstructed.
In addition, you must periodically clean the dust and dirt that accumulate on these
holes in time.
E
LECTRICAL CONNECTION
• Never use an extension cable.
• The electrical outlet receptacle must be grounded and checked by an authorized
person.
• Location of the electrical wiring must comply with the dimensions specified in the
manual.
Please wait for 3-6 hour before energizing the product to protect it
against possible damages. This way, the refrigerant and the lubricants in
the system get balanced.
WARNING
WATER CONNECTION:
• Pressure of the mains water must be in compliance with the values specified in
the manual.
• Location of the water system must comply with the dimensions specified in the manual.
CAUTION
RISK OF ELECTRIC SHOCK
Electrical grounding is necessary. This appliance is equipped with a
three-pin plug to protect you against possible electric shocks.
• Do not remove the round grounding terminal from the plug.
• Do not use two-pin grounding adapters.
• Do not use extension cables to energize the product.
ATTENTION
Do not connect the grounding cable to the gas pipe. Please have the
grounding checked by a qualified electrician if you are not sure about
the grounding of the product. Do not install a fuse on the neutral line or
grounding circuit.
i
Bypass is recommended for the water filtering system if a reverse
osmosis system is used.
INFO
7
Pr
eparing th
e R
efriger
ator Enclosur
e
8
Electrical Connection
BEFORE INSTALLATION BEFORE INSTALLATION