Zline RBIV-30, Руководство по установке

Страница: 10 / 44

LOCATION OF THE WATER SYSTEM
The water connected to the water mains must be potable.
Location of the water system must be within the range given below.
Water system of the refrigerator must be connected to the water mains system in the house.
The user must be able to switch it on/off with the valve when necessary.
Objects that might pierce the water hoses or cause them to twist must not be present
where the water line is installed.
Pressure of the water system must be between 25-80 psi (1.7-5.5 Bar).
If the water pressure exceeds 80 psi, install a pressure limiting device or water impact
protector to the inlet valve. Never install the product or operate the appliance if it is
possible for the water pressure to exceed 120 psi.
Make sure that there is no water leakage when making the water
connections. Otherwise, there will be water on the floor and the
cabinets will get damaged.
You will need a hose with a minimum length of 60" (1.5 meters) and a
diameter of ¼" for water connections of the product during installation.
A connector that has a thread with an external diameter of ¼ must be
used to connect the hose end to the product.
Before completing the installation, make sure that water flows and there
is no water leakage. Damage may occur if leaks are present.
WARNING
• Check if the floor where the product will be installed is level. Use a
level.
• Check if the cabinet flanges are upright and straight using a level.
• If the product is not level and plumb, problems may arise with the
installation.
WARNING
INSTALLATION INSTALLATION
13
Location of W
ater Sy
stem
14
Pr
eparing th
e R
efriger
ator Enclosur
e