CONNECTING THE WATER LINE TO THE WATER SUPPLY
1. Turn off the water supply.
2. Install a hand shut-off valve in an accessible location, such as under the sink. This
is optional, but strongly recommended, and may be required by local codes.
3. Install the hot water inlet line, using at least 3/8” tubing. Route the line as shown
in the figure above and extend it forward at least 18 in. from the rear wall of the
enclosure.
4. Adjust the water heater to a temperature of 120° F to 150° F.
5. Flush the water line to clean out any debris.
Note:
The hot water pressure must be between 20 and 120 psi
(138 and 827 kPa).
BEFORE INSTALLATION
11
W
ater Connection