Installation
Registering the 2010-2-PAK-900
A 2010
−2-PAK-900 Panel Activation Key (PAK) is required for each control panel
that requires the 900 Series protocol.
Follow these steps to register or unregister the PAK. Installer level access is
required.
To register the PAK:
1. Insert the PAK into either of the USB type A slots on the control panel main
board.
2. On the control panel LCD, select Panel Setup, and then select Panel Activ.
Key.
The LCD displays two options: Register New PAK and Unregister PAK.
3. Select Register New PAK. The PAK information is displayed on the LCD.
Confirm that the details are correct and press Continue.
The PAK information includes: The PAK type, the PAK serial number, and the
host control panel serial number (added when registration is complete).
4. Press Register, and then press Yes to confirm the registration.
5. Press Apply to apply the registration details to the panel, or Continue to
register more PAKs for the same control panel.
To apply the 900 Series protocol:
1. Remove the PAK from the USB slot.
2. Insert a jumper onto JP4 on the control panel main board, and then restart the
control panel.
When the panel restarts, the System Update menu is displayed. This menu is
only available in English.
3. Select Load 900 Series Protocol, and then press the jog dial to confirm the
selection.
4. When the update is complete, remove the jumper from JP4, and then press
Reboot to restart the control panel.
The control panel is now configured to use the 900 Series protocol and devices.
To unregister the PAK:
1. Insert the PAK into either of the USB type A slots on the control panel main
board (see figure).
2. On the control panel LCD, select Panel Setup, and then select Panel Activ.
Key.
3. Select Unregister PAK and follow the on-screen instructions.
