Zirkon zahn titanium spectral-colouring anodizer, Руководство оператора и по техническому обслуживанию

Страница: 20 / 44

20 20 KAPITEL 4
TRANSPORT AND INSTALLATION
SETTING UP AND INSTALLATION
Important instructions for setting up the device
The Titanium Spectral-Colouring Anodizer should be operated under the following conditions
only:
- Up to 2000 m above sea level.
- Ambient temperature, in the range from 15 °C to 30 °C.
- Do not expose the system to direct solar radiation.
- Maximum relative air humidity of 75% at 30 °C;
- The Titanium Spectral-Colouring Anodizer may only be moved and put down on surfaces with
suitable stability, in a dry place and in a non-corrosive environment.
- Stable, non-slip installation surface, which can bear a minimum weight of 200 kg.
- Safety distance of min. 2 m to combustible material.
- Safety distance of min. 2 m to water.
- Safety distance of min. 1.5 m to all sides (for cooling air, access).
- Place the table on a flat ground and align the work surface horizontally.
- Provide for adequate work height (consider the height of the front glass in raised position).
- Work and danger area must be easily visible and lit (at least 500 lux).
- Make sure the Titanium Spectral-Colouring Anodizer is installed in such a way that it allows
easy removal of the power plug in case of emergency.
- An electrical socket with a power output of 100 - 240 V is required as fixed connection. Lay
connection cable protected with strain relief. The electrical connection and its mains fuse
must be set up according to the valid national standards. The functioning of grounding and the
protective conductor must be checked before starting.
- Power supply must be installed and attached by an expert.
The equipment must be easily accessible from all sides for operation and possible component
exchange.
- The device must not be connected to the electric circuit during the installation phase: danger of
electric shock.