Zipper Mowers ZI-HS18EZ, Руководство по эксплуатации

Страница: 37 / 57

Hydraulická štípačka / Hydraulic log splitters ZI-HS13E/ZI-HS18EZ/ZI-HS25Z / ZI-HS25EZ Strana 37
INSTALLING PTO DRIVESHAFT
The log splitter can be driven
by a PTO driveshaft (not pro-
vided with the log splitter)
that transmits torque from
tractor during normal opera-
tion. The PTO driveshaft rep-
resents
extreme danger.
Ready and understand all of
the safety and operating in-
structions manual that came
with the PTO driveshaft.
1. Back the rear of the tractor toward the log
splitter. Position the lower draft arms close
enough to the splitter’s hookup pins. Apply the
tractor parking brake and turn the engine off.
2. Block the rear wheels on both sides in front
and back with wedges or other appropriate
objects.
3. Slide the lower draft arms onto the splitter
hookup pins and secure with locking pins.
4. Position the upper draft arm inside the
mounting bracket and align with the mounting
bracket holes. Insert the hitch pin to secure
the upper draft arm in place.
The PTO shaft end from the
gearbox has a diameter of 1-
3/8" (34,8mm) and a 6-spine
fitting (standard category 1
PTO).
5. Slide the PTO driveshaft over the PTO shaft
ends on the gearbox and tractor respectively.
Press inward on the spring pins that are lo-
cated on both ends of the PTO driveshaft.
Continue sliding the driveshaft over the PTO
shaft ends until the spring pins pop out and
lock into the detents in the PTO shaft ends.
Keep splitter PTO shaft end (1)
and tractor PTO shaft end (2)
parallel as viewed from above
and from the sides of the shafts.
Maintain PTO shaft joint angles (
) as small as possible.
6. Secure the PTO shaft safety chains to sta-
tionary parts of the log splitter and tractor to
stop the guard from turning.