Zipper Mowers ZI-BHS605, Руководство пользователя

Страница: 24 / 34

DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  24
ZI-BHS605
19 DISPOSAL
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist
retailer, he is obliged in certain countries to dispose of your old machine
properly.
20 TROUBLESHOOTING
W A R N I N G
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always switch off the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to get the problem fixed.
Problem Possible Cause Solution
Engine does not
start
1. No ignition spark
2. No fuel
3. Engine "sunk"
4. Recoil starter must
be pulled tighter
when the machine
is new
1. Check the spark plug.
2. Press fuel pump. If the problem persists, contact
your local retailer.
3. Pull the starter three times with the choke-lever in
closed position. If the engine does not start, set the
choke-lever to "C1" and carry out the normal
starting procedure. If the engine still does not
start, repeat the procedure with a new spark plug.
4. Contact your local retailer.
Engine starts but
does not accelerate
1. Carburettor should
be adjusted
1. Contact your local retailer
Engine starts but can
only run on full
power and on half
choke.
1. Carburettor should
be cleaned,
readjusted or
replaced.
1. Contact your local retailer
Engine does not run
on full power and
smokes heavily
1. Check the
petrol/oil mixture.
2. Dirty air filter
3. Carburettor should
be readjusted,
repaired or
replaced
1. Use fresh fuel and the correct two-stroke mixture.
2. Clean or replace air filter
3. Contact your local retailer
Engine starts, runs
and accelerates but
cannot run idle
1. Carburettor should
be adjusted
1. Contact your local retailer
Oil leaks from the
exhaust.
1. Trimmer is not
used at full power
2. Check the
petrol/oil mixture
3. Carburettor should
be adjusted
1. Use full power
2. Use fresh fuel and the correct two-stroke mixture.
3. Contact your local retailer