Zipper Mowers 912003923904 0, Руководство пользователя

Страница: 35 / 45

OPERATION
ZIPPER MASCHINEN GmbH  www.zipper-maschinen.at Seite 35
Motorsense / brush cutter ZI-MOS145G Seite 35
15.1.4 Start
Assure yourself prior to every start that the fuel-oil
mixture is shook up well. Do not use self –mixed mix-
tures older than one month.
Check all machine parts for condition and all connec-
tions for tight set.
Put the main switch
G into position I.
Apply the choker by putting lever J into upper position.
The choker is used for starting the machine when it is cold.
Then press 2-3 times the primer pump (
28 ).
You find the primer between fuel tank and carburettor-
bottom.
Now start the engine buy pulling the starter
K out briskly.
When the machine has started, shut the choker J off again.
Let the machine run for one minute in idle run.
TO STOP THE MACHINE IT IS ENOUGH TO PUT THE
MAIN SWITCH G INTO POSITON O (=STOP)
15.1.5 Refuel
Use 2-stroke HQ oil. Ask for advice from your local reseller.
ZIPPER Maschinen recommends using ready-mixed high qual-
ity fuel (e.g. ASPEN2). Self-mixed fuel disaggregates after a
certain time.
There is a risk of damaging the motor due to insufficient lu-
brication. Ready-mixed fuel never disaggregates even after
long periods of storage.
If you wish to mix your fuel yourself, you can use the mixing
cup L .
Fill the cup up with petrol until it reaches the mark 576,92.
Now fill the oil in until it reaches the mark 600.
Tighten the cap
M well and mix the fuel by shaking the tank.
15.1.6 Throttle control
Press N .
Now you can press throttle lever O .
You can switch into continuous operation by pressing P