OPERATION
29
ZI-STE1000INV
•
At
cold start
set the choke lever (3) to position „START“.
•
If the engine runs smoothly set the choke lever (3) to posi-
tion „RUN“.
•
At
warm start
(the engine was running and is still warm) set
the choke lever (3) to position „RUN“.
•
If the engine fails to start after 5 attempts, set the choke lev-
er to position „START“ and try again.
•
Start the engine with the recoil starter.
•
Grab the starter handle (4) and pull it out slowly. The re-
sistance becomes strongest at a certain point. This point
corresponds to the compression point. Let the rope roll back
a little from this point and then pull it out powerfully.
Slowly return the starter handle (4).
If the engine does not start, try again.
Normally start: 3-4 attempts.
13.6.2
Switch the machine off
CAU TION
In case of emergency stop the machine directly with the fuel tap.
Under normal circumstances, switch off the machine as follows:
•
Shut down the connected devices and disconnect them from the machine.
•
Let the machine run for some time without connected devices to cool down.
•
Switch off the machine by putting the ON-OFF switchto position „OFF“.
•
Set the lever on the fuel filler cap to the "OFF" position.
NOTE:
In case the machine is being stopped, during transport or storage, the fuel filler cap lever, the
choke and the ON-OFF switchneed to be set to the "OFF" position.
13.6.3
ECO-mode
The ECO-mode is recommended to reduce fuel consumption
during operation.
With the activated ECO-mode, the machine automatically re-
duces the engine speed depending on the load. This results in
less fuel consumption.
NOTE:
In case of low power output, the ECO-mode can be acti-
vated (switch (1) in position "ON").
In case of high power output and DC operation, the ECO-mode
must always be deactivated (switch (1) in position "OFF").
13.7
AC Operation
1.
Verify that the green indicator light (running) is on after starting the engine. This indicates that
the machine is working properly.
2.
Check that the ON-OFF switch of the electrical devices to be used is set to "OFF".
3.
Connect the device to the AC-socket.
4.
Start the device.
