OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
38
ZI-RWM84
18.3
Control Panel
N° Description
N° Description
1
START Key:
Press the
START key
to
start a spin cycle. Note: Lower the
protection hood to activate a spin cycle
NOTICE:
Lower the hood to activate a
spin cycle.
9
USER Key:
Repeat pressing this key
to swich to the desired user. Press
Fn+ USER key
to save presetting
data in each user environment.
2
STOP Key:
Press STOP key to perform
the following functions in each status:
· Stop spin cycle in emergency when the
wheel is spinning
· Activate the wheel lock (solenoid
brake) when the wheel is not spinning,
deactivate it by pressing STOP key again.
10
Vehicle Selection (MODE) Key:
Press this key to select the vehicle
wheel type.
3
HIDE Key:
Press this
key to enter the
hidden weight function (behind the
spokes) when ALU-S program is
activated.
11
"A+" Key:
Press this key to raise up
value of rim distance
A
.
4
SPL Key:
Press the
S
mart
P
osition
L
ocator key to locate the wheel to the
balancing weight position.
12
"A-" Key
: Press this key to trim
down value of rim distance
A
.
5
Fn / Static Key:
Press this key to toggle
between dynamic and static balancing
modes.
13
"
W+" Key:
Press this key to raise
up value of rim width
W
.
6
<T Key:
Press this key to indicate actual
imbalance weight amount reading below 5
grams o r ¼ ounce.
14
"W-" Key:
Press this key to trim
down value of rim width
W
.
7
C Key:
Press this key to perform the
Following functions in each status:
· Recalculate the balancing result after a test
spin done, after changing either of A, W and D
data, press C key to do recalculation without
additional spin;
· Exit program during in process of some
Programs.
15
"D+" Key:
Press this key to raise up
value of rim diameter
D
.
8
ALU Key:
Press this key to ALU-S balancing
program.
election of functions 1
→
2
→
3
→
4
→
5
16
"D-" Key:
Press this key to trim
down value of rim diameter
D
.
