ZIPPER MASCHINEN 9120039233512, Руководство пользователя

Страница: 28 / 34

TROUBLE SHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  28
ZI-ASA305A
If you are unable to carry out necessary repairs properly and/or do not have the required training,
always consult a specialist to solve the problem.
Trouble Possible cause Solution
Device will not start
 No mains voltage. Main circuit
breaker is tripped.
 Check the socket, mains supply
cable, cord, mains plug; if
necessary, have them repaired
the main fuse
 On-Off switch is broken  Repair necessary
 Motor faulty  Repair necessary
Motor will not run
 Defektive or broken switch  Repair necessary
 Defective or damaged power
cord
 Repair necessary
 Open circuit, loose
connections, or burned out
motor
 Repair necessary
 Low voltage
 Check the power line for the
proper voltage. Use another
circuit or have a qualified one
Motor slow to start or fails
to reach full speed
 Burned or defektive motor
 Check motor, replace if
necessary
 Worn brushes
 Inspect brushes, replace if
necessary
Motor overheats
 Motor overload
 Reduce load by slowing dust
production
 Insufficient motor cooling  Clean sawdust from motor
Tripping circuit breaker or
fuses
 Motor overload
 Reduce load by slowing dust
production
 Improper capacity of circuit
breaker or fuses
 Use proper capacity circuit
breaker or fuse
Unit has vibration or noisy
operation
 Motor or components are loose
 Inspect/replace any stripped or
damaged bolts/nuts and
retighten
 Motor bearings faulty  Repair necessary
Loud, repetitious noise or
excessive vibration coming
from dust collector
 Dust collection canister is full  Empty collection canister
 Filter cartridge/bag is dirty or
damaged
 Clean filter cartridge/bag or
replace
 Suction hose restricted
 Remove hose from dust collector
inlet and unlock the restriction in
the hose. A plumbing snake may
be necessary.
 The lumber is wet and dust is
not flowing through the hose
smoothly
 Process lumber with less than
20% moisture content
 There is a leak in the suction
hose
 Inspect and replace suction hose
Motor stalls
 Short circuit in motor
 Take to a qualified service
technican
 Incorrect fuses or circuit
breakers
 Replace with correct fuse or
circuit breaker for the circuit
 Overload circuit
 Turn off other machines and
retry
 Low voltage
 Check the power line for the
proper voltage. Use another
circuit or have a qualified
electrician upgrade the service