SAFETY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
21
ZI-ASA305A
The machine is solely designed for indoor use.
Choose a level, vibration-free and non-slip surface for the installation location.
Ensure sufficient space around the machine!
Keep your work area dry and tidy! An untidy work area may cause accidents. Avoid slippery
floor.
Keep the area around the machine free of obstacles (e.g. dust, chips, cut parts, etc.).
Make sure the work area is lighted sufficiently.
Work in a well ventilated area! If necessary, use dust protection.
Protect the machine from dampness (causing a short circuit).
Do not overload the machine.
Use power tools and machines never in the vicinity of flammable liquids and gases (danger
of explosion)
Do not smoke in close proximity to the machine.
Regularly check the dust collector hood for debris and clean it if necessary.
11.4
Electrical Safety
Each time you work with an electrically operated machine, caution is advised! There is a risk
of electric shock, fire, cutting injury.
Shut down the machine and disconnect it from the power supply when the machine is not
in use and before carrying out any adjustment, conversion, cleaning, maintenance or repair
work. Make sure that the main switch is in the "O" position before connecting the machine
to the power source.
Only operate the machine from a power source that is protected by a FI switch!
Never use the machine with a defective ON-OFF-switch.
Water that enters the machine increases the risk of electric shock. Do not expose the
machine to rain or moisture.
The plug of an electrical tool must strictly correspond to the socket. Do not use any adapters
together with earthed electric tools.
A damaged or entangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the machine. Keep the cable away
from heat, oil, sharp edges or moving parts.
Only use suitable extension cords.
Make sure that the machine is earthed.
Avoid any physical contact with earthed parts of the machine.
The machine may only be used in humid environments if the supply is protected by a residual
current circuit breaker.
11.5
Special Safety Instructions for that machine
The machine is for indoor use only.
Work with gloves on rotating parts is not permitted!
Wood dust is generated when the machine is in operation. Therefore, connect the machine
to a suitable extraction system for dust and chips during installation!
Always switch on the dust extraction device before you start machining the workpiece!
Always turn off the woodworking machine first before you stop the dust collector.
Do not touch parts that might be hot from operation. Allow parts to cool before attempting
to maintain, adjust or service.
Excessive noise can cause hearing damage and temporary or permanent hearing loss. Wear
hearing protection certified to health and safety regulations to limit noise exposure.
Inhaling wood dust is dangerous to health! Always wear a dust protection mask and safety
glasses when emptying the collection bag.
When disposing of the chip waste, ensure that it is disposed of in an environmentally friendly
manner!
Do not insert any objects into the extraction opening and keep it free of deposits that could
impair the extraction performance.
The suction of flammable or combustible vapours, liquids, dust, ash or chips (gases, fuel,
cleaning agents, paint residues, hydrogen, coal, magnesium, grain dust, stone dust, hot
ash, cigarette butts, etc.) is strictly prohibited.
